Attending an open for inspection can be a daunting task for anyone, no matter how experienced you are.
Don’t let the styled décor sway you too much, there’s more to your new home than just how much you love or hate the interior.
Remember to look at the building itself as much as you look at things like the layout of the kitchen and whether or not there’s an en-suite. If you’re serious about buying the property it pays to be thorough and a few simple maintenance checks can sometimes make the difference between buying your dream house and stepping into a costly nightmare.
If you’re ever in doubt, contact a qualified building inspector to put your mind at rest, but this list is a good place to start when looking for potential problems – and avoiding some hassles down the line.
Take this with you on your next OFI Saturday.
Try to look at the walls backing onto these areas for any signs of moisture penetration or water leaks. This is not a structural defect but can be a costly maintenance item for repair.
Look at the ceilings to see if they are fixed firmly flush into place and do not have a ‘parachute’ appearance. This can be easily done by shining a torch across the ceilings, as this will show up all deflections and defects in the ceiling sheets.
All cabinets should be opened to detect if there is a smell of damp, mould and mildew. Any damp smells can be an indication of water leaks or even rising damp.
The internal and external walls should be visually checked to note any large wall cracks. Cracks that are greater than 2.0mm in width or properties with excessive cracking can be cause for concern and should be further inspected by a qualified building inspector.
Mould can just look like dirty clouds on the walls and ceilings, especially if they have been recently cleaned. Mould has to be cleaned by professional mould remediation companies and can be quite expensive to have removed. Plus there is the question of the initial cause of the mould, is it more than just bad upkeep?
The internal wall plastering can be easily checked for fine hairline cracks (map cracking, as they take on the appearance of a map). These cracks are caused by the incorrect application of the wall plastering at the time of construction. Once these cracks are found in one area of the property you will usually find it in multiple areas. The cracking plaster can crack further and even come loose, especially when wall fixings for paintings are installed.
Look up the lines of the roof externally if possible to check if they are straight and free from deflections.
The roof gutters may look great from ground level but if checked from their top side they may appear very corroded and soon require replacement.
Do a quick walk around the external perimeter of the home to check that all roof downpipes are discharging into stormwater soak wells and not just onto the ground. You should also look for any signs of past flooding or excess water flow around the roof downpipe bases as this can be an indication that the soak wells are not suitably sized or require cleaning out, which can be a costly maintenance item. To install stormwater soak wells on an established property can be very expensive, as paving, concrete and garden beds may need to be excavated to install the drains.
This item is important for multi-storey properties. There should be small holes evident above and below window and door frames and along the suspended slab levels. The holes will usually be spaced approximately 1200mm apart. These holes allow water to escape from the cavity walls. Without these holes water can penetrate the internal walls of the home and cause ongoing and expensive maintenance.
If you’re in any doubt, it can be a good idea to get a professional in to give a detailed report for peace of mind.
Article taken from http://www.realestate.com.au/blog/open-for-inspection-detective-10-things-to-check-before-you-buy/?rsf=edm:inspection:oct:2015:c